Rubber seating rings in the RIS 2 series are primarily intended to cushion insert bearings in pressed steel pillow (plummer) block housings. Located between the bearing outer ring and housing bore, they dampen vibration and noise and enable the bearings to be displaced slightly in their housings and to accommodate minor shaft expansion or misalignment.
| Bearing outside diameter | D |
1.85 in
|
|---|
| B |
0.551 in
|
Inner width rubber seating ring |
|---|---|---|
| C |
0.748 in
|
Outer width rubber seating ring |
| d1 |
1.622 in
|
Inner diameter rubber seating ring |
| d2 |
1.843 in
|
Inner diameter rubber seating ring |
| D1 |
2.059 in
|
Outside diameter rubber seating ring |
| r |
min. 0.039 in
|
Chamfer radius rubber seating ring |
| Mass rubber seating ring |
0.022 lb
|
Reviews
There are no reviews yet.