Withdrawal sleeves are slit tapered sleeves that are used to mount bearings with a tapered bore onto the cylindrical seat of stepped shafts. This AH(X) sleeve has dimensions in accordance with ISO standards and is a basic design for mounting and dismounting. The sleeve is located on the shaft by a lock nut or an end plate. The lock nuts and appropriate locking device can be ordered separately. End plates are not manufactured by SKF.
| d1 |
105 mm
|
Bore diameter |
|---|---|---|
| d |
110 mm
|
Outside diameter small taper |
| B1 |
98 mm
|
Width |
| B2 |
102 mm
|
Width sleeve and bearing before sleeve is driven into bore |
| G |
M120x2
|
Thread |
| G1 |
16 mm
|
Length thread |
|
1:12
|
External taper |
| Mass withdrawal sleeve |
1.25 kg
|
Reviews
There are no reviews yet.