DTW-12500-J2GPolyurethane snap-in wiper seal with a single lip, two additional static lips and notches on the inside edge

Hydraulic wiper seals prevent contaminants from entering a cylinder assembly and hydraulic system. DTW seals are polyurethane snap-in wiper seals. They have a single-lip design, with two additional radial and axial static seal lips that maintain the sealing contact and keep the wiper tight in the housing. Notches on the inside edge prevent the seals from trapping in pressure or being pushed out by pressure.

SKU: DTW-12500-J2GPolyurethane snap-in wiper seal with a single lip, two additional static lips and not Category:
Dimensions - DTW-12500-J2G

Dimensions

d
317.5 mm
Rod diameter
D
342.82 mm
Housing groove diameter
D2
334.24 mm
Housing shoulder diameter
L
12.67 mm
Housing groove width
S
12.66 mm
Radial depth
R
max. 0.64 mm
Groove radius
C
min. 12.7 mm
Lead-in chamfer length on rod
Tolerances
tol d     Tolerance for rod diameter is determined by the rod seal.
tol D
0.15 mm
Upper limit deviation
0 mm
Lower limit deviation
tol D2
0.127 mm
Upper limit deviation
0 mm
Lower limit deviation
tol L
0.102 mm
Upper limit deviation
0 mm
Lower limit deviation

Materials

Primary sealing element
Polyurethane (TPU U-1003)

Operating conditions

Speed
max. 0.75 m/s
Temperature
min. -40 °C
Temperature
max. 120 °C
Maximum values of application parameters (e.g. pressure, speed, temperature) should not be applied continuously nor simultaneously.

Reviews

There are no reviews yet.

Be the first to review “DTW-12500-J2GPolyurethane snap-in wiper seal with a single lip, two additional static lips and notches on the inside edge”

Your email address will not be published. Required fields are marked *