Single direction thrust ball bearings, with sphered housing washer, can accommodate axial loads in one direction. They must not be subjected to any radial load. Many of the components are interchangeable. The shaft washers have a ground bore that enables an interference fit. The sphered housing washers can accommodate initial misalignment when configured correctly with a sphered seat washer or a machine component with a sphered surface.
| d |
90 mm
|
Bore diameter |
|---|---|---|
| D |
155 mm
|
Outside diameter |
| H |
54.6 mm
|
Height |
| H1 |
59 mm
|
Height bearing including seat washer |
| d1 |
≈ 155 mm
|
Outside diameter shaft washer |
| D1 |
≈ 93 mm
|
Inner diameter housing washer |
| D2 |
120 mm
|
Inner diameter sphered seat washer |
| D3 |
160 mm
|
Outside diameter sphered housing washer |
| C |
18 mm
|
Height sphered housing washer |
| R |
112 mm
|
Radius sphered housing washer |
| s |
40 mm
|
Centre height housing washer sphere |
| r1,2 |
min. 1.5 mm
|
Chamfer dimension washer |
| da |
min. 129 mm
|
Abutment diameter shaft |
|---|---|---|
| Da |
max. 120 mm
|
Abutment diameter housing |
| ra |
max. 1 mm
|
Fillet radius |
| Basic dynamic load rating | C |
182 kN
|
|---|---|---|
| Basic static load rating | C0 |
440 kN
|
| Fatigue load limit | Pu |
14.6 kN
|
| Reference speed |
1 400 r/min
|
|
| Limiting speed |
2 000 r/min
|
|
| Minimum load factor | A |
1.3
|
| Mass bearing (including seat washer where applicable) |
4.7 kg
|
| Seat washer |
U 318
|
Reviews
There are no reviews yet.