Single direction thrust ball bearings, with sphered housing washer, can accommodate axial loads in one direction. They must not be subjected to any radial load. Many of the components are interchangeable. The shaft washers have a ground bore that enables an interference fit. The sphered housing washers can accommodate initial misalignment when configured correctly with a sphered seat washer or a machine component with a sphered surface.
| d |
40 mm
|
Bore diameter |
|---|---|---|
| D |
68 mm
|
Outside diameter |
| H |
20.3 mm
|
Height |
| H1 |
23 mm
|
Height bearing including seat washer |
| d1 |
≈ 68 mm
|
Outside diameter shaft washer |
| D1 |
≈ 42 mm
|
Inner diameter housing washer |
| D2 |
55 mm
|
Inner diameter sphered seat washer |
| D3 |
72 mm
|
Outside diameter sphered housing washer |
| C |
7 mm
|
Height sphered housing washer |
| R |
56 mm
|
Radius sphered housing washer |
| s |
28.5 mm
|
Centre height housing washer sphere |
| r1,2 |
min. 1 mm
|
Chamfer dimension washer |
| da |
min. 57 mm
|
Abutment diameter shaft |
|---|---|---|
| Da |
max. 55 mm
|
Abutment diameter housing |
| ra |
max. 1 mm
|
Fillet radius |
| Basic dynamic load rating | C |
44.2 kN
|
|---|---|---|
| Basic static load rating | C0 |
96.5 kN
|
| Fatigue load limit | Pu |
3.6 kN
|
| Reference speed |
3 600 r/min
|
|
| Limiting speed |
5 300 r/min
|
|
| Minimum load factor | A |
0.058
|
| Mass bearing (including seat washer where applicable) |
0.35 kg
|
| Seat washer |
U 208
|
Reviews
There are no reviews yet.