These single row angular contact ball bearings can accommodate radial and axial loads acting simultaneously, where the axial load acts in one direction only. They can operate at high speeds and, depending on the variant, even very high speeds. They are more suitable than deep groove ball bearings for supporting large axial forces acting in one direction.
| d |
1 000 mm
|
Bore diameter |
|---|---|---|
| D |
1 420 mm
|
Outside diameter |
| B |
185 mm
|
Width |
| d1 |
≈ 1 169 mm
|
Shoulder diameter of inner ring (large side face) |
| d2 |
≈ 1 169 mm
|
Shoulder diameter of inner ring (small side face) |
| D1 |
≈ 1 262 mm
|
Shoulder diameter of outer ring (large side face) |
| a |
442 mm
|
Distance side face to pressure point |
| r1,2 |
min. 7.5 mm
|
Chamfer dimension |
| r3,4 |
min. 4 mm
|
Chamfer dimension |
| da |
min. 1 028 mm
|
Diameter of shaft abutment |
|---|---|---|
| Da |
max. 1 392 mm
|
Abutment diameter housing |
| Db |
max. 1 405 mm
|
Diameter of housing abutment |
| ra |
max. 6 mm
|
Radius of fillet |
| rb |
max. 3 mm
|
Radius of fillet |
| Basic dynamic load rating | C |
1 630 kN
|
|---|---|---|
| Basic static load rating | C0 |
5 400 kN
|
| Fatigue load limit | Pu |
67 kN
|
| Reference speed |
360 r/min
|
|
| Limiting speed |
380 r/min
|
|
| Minimum axial load factor | A |
223
|
| Minimum radial load factor | kr |
0.085
|
| Limiting value | e |
0.8
|
| Calculation factor (single, tandem) | X |
0.39
|
|---|---|---|
| Calculation factor (single, tandem) | Y0 |
0.33
|
| Calculation factor (single, tandem) | Y2 |
0.76
|
| Calculation factor (back-to-back, face-to-face) | X |
0.63
|
|---|---|---|
| Calculation factor (back-to-back, face-to-face) | Y0 |
0.66
|
| Calculation factor (back-to-back, face-to-face) | Y1 |
0.78
|
| Calculation factor (back-to-back, face-to-face) | Y2 |
1.24
|
| Mass |
890 kg
|
Reviews
There are no reviews yet.