These single row angular contact ball bearings can accommodate radial and axial loads acting simultaneously, where the axial load acts in one direction only. They can operate at high speeds and, depending on the variant, even very high speeds. They are more suitable than deep groove ball bearings for supporting large axial forces acting in one direction.
| d |
500 mm
|
Bore diameter |
|---|---|---|
| D |
720 mm
|
Outside diameter |
| B |
100 mm
|
Width |
| d1 |
≈ 587 mm
|
Shoulder diameter of inner ring (large side face) |
| d2 |
≈ 544 mm
|
Shoulder diameter of inner ring (small side face) |
| D1 |
≈ 640 mm
|
Shoulder diameter of outer ring (large side face) |
| a |
226 mm
|
Distance side face to pressure point |
| r1,2 |
min. 6 mm
|
Chamfer dimension |
| r3,4 |
min. 3 mm
|
Chamfer dimension |
| da |
min. 523 mm
|
Diameter of shaft abutment |
|---|---|---|
| Da |
max. 697 mm
|
Abutment diameter housing |
| Db |
max. 707 mm
|
Diameter of housing abutment |
| ra |
max. 5 mm
|
Radius of fillet |
| rb |
max. 2.5 mm
|
Radius of fillet |
| Basic dynamic load rating | C |
715 kN
|
|---|---|---|
| Basic static load rating | C0 |
1 600 kN
|
| Fatigue load limit | Pu |
27.5 kN
|
| Reference speed |
900 r/min
|
|
| Limiting speed |
900 r/min
|
|
| Minimum axial load factor | A |
19
|
| Minimum radial load factor | kr |
0.085
|
| Limiting value | e |
0.8
|
| Calculation factor (single, tandem) | X |
0.39
|
|---|---|---|
| Calculation factor (single, tandem) | Y0 |
0.33
|
| Calculation factor (single, tandem) | Y2 |
0.76
|
| Calculation factor (back-to-back, face-to-face) | X |
0.63
|
|---|---|---|
| Calculation factor (back-to-back, face-to-face) | Y0 |
0.66
|
| Calculation factor (back-to-back, face-to-face) | Y1 |
0.78
|
| Calculation factor (back-to-back, face-to-face) | Y2 |
1.24
|
| Mass |
130 kg
|
Reviews
There are no reviews yet.