These single row angular contact ball bearings can accommodate radial and axial loads acting simultaneously, where the axial load acts in one direction only. They can operate at high speeds and, depending on the variant, even very high speeds. They are more suitable than deep groove ball bearings for supporting large axial forces acting in one direction.
| d |
460 mm
|
Bore diameter |
|---|---|---|
| D |
620 mm
|
Outside diameter |
| B |
74 mm
|
Width |
| d1 |
≈ 513 mm
|
Shoulder diameter of inner ring (large side face) |
| D1 |
≈ 569.5 mm
|
Shoulder diameter of outer ring (large side face) |
| a |
163 mm
|
Distance side face to pressure point |
| r1,2 |
min. 4 mm
|
Chamfer dimension |
| r3,4 |
min. 1.5 mm
|
Chamfer dimension |
| da |
min. 475 mm
|
Diameter of shaft abutment |
|---|---|---|
| Da |
max. 605 mm
|
Abutment diameter housing |
| Db |
max. 613 mm
|
Diameter of housing abutment |
| ra |
max. 3 mm
|
Radius of fillet |
| rb |
max. 1.5 mm
|
Radius of fillet |
| Basic dynamic load rating | C |
507 kN
|
|---|---|---|
| Basic static load rating | C0 |
1 040 kN
|
| Fatigue load limit | Pu |
19 kN
|
| Reference speed |
1 000 r/min
|
|
| Limiting speed |
1 100 r/min
|
|
| Minimum axial load factor | A |
5.34
|
| Minimum radial load factor | kr |
0.083
|
| Limiting value | e |
0.68
|
| Calculation factor (single, tandem) | X |
0.41
|
|---|---|---|
| Calculation factor (single, tandem) | Y0 |
0.38
|
| Calculation factor (single, tandem) | Y2 |
0.87
|
| Calculation factor (back-to-back, face-to-face) | X |
0.67
|
|---|---|---|
| Calculation factor (back-to-back, face-to-face) | Y0 |
0.76
|
| Calculation factor (back-to-back, face-to-face) | Y1 |
0.92
|
| Calculation factor (back-to-back, face-to-face) | Y2 |
1.41
|
| Mass |
58 kg
|
Reviews
There are no reviews yet.